INFUSION INPUT MESH 2X7,5CM (YELLOW) 1 ML

Vacuum bag for infusion or vacuum. 65 microns, blue, width 2 meters (folded in half)

complex 1,5m x 100m_x000D_ _x000D_ the COMPLEX mesh integrates the drainage mesh, the perforated film and even the Peel Ply, and saves time, resin and effort in separating the consumables from the finished piece.

Pyramid for infusion, for 12 mm hose To connect the distribution system with a resin inlet and outlet hose. Made of high density polyethylene.,

Sealing tape for the vacuum bag, 15 meter roll, ideal for resin infusion, vacuum compaction and sealing all joints, from the bag to the pump, through the resin trap.

155mm long wooden sticks for mixing all types of resins. Pack of 25 units

Apply the Peel ply to the entire surface you want to separate from the fiberglass / carbon and other consumables.

Flowmesh is a perfect drain mesh for learning, thanks to its flexibility and ease of application. It comes with black weft threads that indicate the optimal resin flow direction. Thanks to its great flexibility, it is the most recommended mesh for small surfaces with complicated, angular areas.

Low density polyethylene spiral, for resin distribution in an infusion system.

SR 8100 epoxy resin with SD 8824 hardener (Standard) specific for resin infusion.

Basic consumables set to make your first resin infusion or a small project or repair. materials for 1m2

Jaw / Pliers to close the passage of resin or air in the resin infusion system for composites. Total hose tightness quickly and easily.

Perforated Polyethylene film that detaches from most resin systems - for infusion and vaccuum works

Bag for infusion or vacuum. 50 microns, orange, 30cm width (tubular)._x000D_

Suitable for small vacuum systems, it saves resin by having a smaller inside diameter.

Removable glass / carbon fiber sealant. It does not affect the mechanical properties of the infused piece

RTV (Room Temperature Vulcanization) Silicone Standard for all types of fast, flexible and non-stick molds.

Liquid for making a non-stick film between the mold and the reproductions. Ideal as a complement to the mold wax.

Unidirectional carbon fiber fabric of 200gr / ml

Useful part to divide the resin distribution circuit in the infusion

TEFLON TAPE 12MX12MMX0.075MM (UD) sealing gasket to seal all vacuum connections

Thinner fiber for first layer or reinforced gelcoats. Low resin consumption, very useful to reach every corner. It is also suitable for use with Jesmonite resin.

Apply the Peel ply to the entire surface you want to separate from the fiberglass / carbon and other consumables.

Suitable for small vacuum systems, it saves resin by having a smaller inside diameter.